If you have a SolarEdge system with LCD screen (if it doesn’t have the LCD screen please go to the end of this section) this is one of the most common problems we see with SolarEdge technology. Note: If all of your panels are not be found, it doesn’t mean that your system is not working, it could be degraded mean that some of the optimizers have failed or something else is going on.
Step One: Turn the Black Barrel Switch to OFF!
Step Two: Turn the red switch on the left side the P I/O switch to O
Step Three: turn barrel Switch to On.
Step Four: Tap the OK button after about 20 seconds the screen should come on.
Step Five: Press and hold OK button until screen says entering pairing mode
Step Six: Screen ask you tell you to turn P and I/O switch to I. Do it!
Step Seven: Screen displays entering pairing mode wait until you are old and retired. 186 seconds countdown begins. Note: the screen may shut off during this process.
Step Eight: Screen displays Waking up 295 seconds remaining. Wait! you should hear the inverter turning on.
Note: it may slowly find your solar panels and watch for the communications LED to Flash. Each time it flashes it should be finding a solar panel. If it does not find all your solar panels after 5-10 minutes you might have a problem.
Step Nine: Verify P_OK: Found number of panels/your number of panels. Note: the example above is missing two panels but it did find them. 26/28
Step Ten: verify Pac [W] has a variable number that keeps changing. This is your power being produced.
Solar Edge no LCD Screen! (note if you have a solar edge inverter with no screen, you will need the My Solar edge app from the app store or google play. Once you have the app, you will need to scan the inverter QRCODE next to the inverter serial number. This should get you limited access, control, and data to your solar system. If you don’t find what you are looking for or need help please contact us or fill out a contact us form